Vices, dividers and tables

Smooth jaw for machine vice VMC-160HV Grinded, hardened. The jaw is without an upper attachment

Smooth jaw for machine vice VMC-200HV Grinded, hardened.

Basic smooth jaws for pneumatic vice VMC-5P Price is for 1 pair, ie 2 pieces of jaws

Basic smooth jaws for pneumatic vice VMC-6P and VMC-6PL Price is for 1 pair, ie 2 pieces of jaws

Locking pin for sliding jaw - for vice VNC-160H Position: No.6 Diameter of pin: 20mm Diameter: 22mm Diameter: 17mm Total length: 150mm If you have bent this pin, it is because the vise has been pulled above the maximum permissible tightening force. We recommend purchasing a pressure gauge for the vise and setting the vise stop to the maximum permitted tightening force. Attention - this bolt was made in the Czech Republic from quality steel - it is not an original manufacturer's bolt. It is quite probable that if you continue to pull the vise, you will not bend this pin anymore = it can loosen the vice and damage something else. © ho.

Set of smooth / clean jaws for machine vice VNC-100H Dimensions - see enclosed catalog sheet. Broušeno, kaleno. Ref. No. 4005-121

Set of smooth / clean jaws for machine vice VNC-125H Dimensions - see enclosed catalog sheet. Broušeno, kaleno. Ref. No. 4005-122

Set of smooth / clean jaws for machine vice VNC-160H Dimensions - see enclosed catalog sheet. Broušeno, kaleno. Ref. No. 4005-123

Knurled jaw(1pcs 29 for machine vice VNC-125H Position No. 3 Dimensions - same as see appendix cat. list. Brushed, hardened.

Knurled jaw(1pcs 29 for machine vice VNC-160H Position No. 3 Dimensions - same as see appendix cat. list. Brushed, hardened.

Bending jaws for vise clamps 100mm These bending jaws are equipped with strong magnets on the back, by means of which they are attached to the wall V!Vise jaws of the vise With the help of these jaws it is possible to make bends The bar consists of segments of different widths. ky(possibility of corner bends)

Bending jaws for vise clamps 125mm These bending jaws are equipped with magnets on the back, by means of which they are attached to the stand Vise jaws of the vise With the help of these jaws it is possible to make bends The bar consists of segments of different widths ( possibility of corner bends)