Vertex nebo jiný
-
TC-312 / GT-12 tapping adapter for machine taps
Quick release attachment / sleeve / insert / collet TC312 / GT12 with slip for machine taps The attachment clamps taps: DIN 371 (reinforced shank): see attached table DIN 376 (classic shank): see attached table Dimensions of the clamping part (insertion into the clamp - see 2nd photo) - the radius stones are 10mm wide, 4mm high and the wall thickness is 3mm. Method of clamping the tap: The taps are secured in the extension by a square and a clamping shank. The tap is firmly held in the extension, it is pulled out after pressing the clamping collar in the front of the extension. Features : The tap is clamped in a suitable collet TC312, which has a torque coupling already preset, or it can be fine-tuned as needed. This insert fits into a thread cutter - see related products. Cannot be used alone.
from 34,23 € with VAT -
TC-820 / GT-20 tapping adapter for machine taps
Quick release attachment / sleeve / insert / collet TC820 / GT20 with slip for machine taps The attachment clamps taps: DIN 371 (reinforced shank): see attached table DIN 376 (classic shank): see attached table Method of clamping the tap: The taps are secured in the extension by a square and a clamping shank. The tap is firmly held in the extension, it is pulled out after pressing the clamping collar in the front of the extension. Features : The tap is clamped in a suitable collet TC820, which has a torque coupling already preset, or it can be fine-tuned as needed. This insert fits into a thread cutter - see related products. Cannot be used alone.
49,92 € with VAT -
TC-1433 / GT-33 tapping adapter for machine taps
Quick clamping attachment / sleeve / insert / collet TC1433 with slip for machine taps Attachment clamps taps: DIN 371 (reinforced shank): see attached table DIN 376 (classic shank): see attached table Tap clamping method: The taps are secured in the extension with a square and a clamping shank. The tap holds firmly in the bit, pulling out after pressing the clamping collar in the front of the bit. Features: The tap is clamped in a suitable TC1433 collet, which has a torque coupling already preset, or it can be fine-tuned as needed. This insert is clamped in the tap - see related products. Cannot be used alone.
92,66 € with VAT -
Insert for M5 tap with torque coupling, TC-312-M5-DIN371, 312-07D
DIN 371 (reinforced shank) : M5 and also M6 DIN 376 (classic shank): M8 Thread clamping method: Taps they are secured behind the square and the shank. The screwdriver holds firmly in the extension, pulling the clamping collar in the front of the extension. Function: The tap is clamped into a suitable TC312 collet that has a pre-set torque clutch or can be fine-tuned as needed. This insert is threaded - see related products. Can not be used alone.
In stock35,39 € with VAT