Two-axis sine magnetic chuck 150x350 mm for angle grinding and EDM, Fixar

Two-axis permanent magnetic sine table with Neomicro permanent magnet is suitable for high precision angle grinding, EDM and measurement. The possibility of tilting in the longitudinal and transverse axis. Angle adjustment is performed using end gauges based on the principle of the sine function. Extreme accuracy even after prolonged use.

Magnet width: 150mm
Magnet length: 350mm
Magnet height: 123mm
Base size: 190 x 385mm
Angle adjustment range: longitudinal 0-45°, transverse 0-30°

Nominal clamping force: 100N/cm2
Pole distance: Steel 1.4mm, brass 0.5mm
Poling : transverse
Clamping surface with even distribution of magnetic force to the edges!!!

Minimum workpiece size: 4x4x1 mm
Magnet over-grinding limit: 7 mm

Hardened base plate for extra stability.
It is optionally possible to equip this table with another fixture (Neomill, Electrofine...) - on request.

This magnet is fitted with a Neomicro magnetic chuck and is ideal for precision grinding of small, thin and large parts as well as EDM. Thanks to the waterproof design, it is possible to use a cooling liquid or immerse it in a dielectric liquid. The upper pole plate is composed of brass and steel lamellae, high stability, accuracy and clamping efficiency are guaranteed by maximum concentration of magnetic force into the surface of the workpiece.

Usage: surface grinding, EDM electroerosive machining.

Package includes: sine mag. clamp, switch key, table for quick angle adjustment, user manual
The clamp is equipped with high-quality permanent neodymium magnets, we provide full warranty and post-warranty service for the magnets.

Cat. no. : SINEC150350

If you