Set for removing inner bearings 8-58 mm, KN 107710

Puller / puller for inner bearings with adapters

This kit is suitable for bearings with an inner diameter of 8 to 58 mm

Kit contains:
1x Sliding hammer
1x Puller
1x Set of 10 adapters: 8-11mm, 12-17mm, 18-23mm, 24- 29mm, 30-34mm, 34-38mm, 39-43mm, 44-48mm, 49-53mm, 54-58mm
1x threaded extension M10x1,5 / M10x1,5
1x threaded reduction M10x1,5 / M8x1,25
1x threaded reducer M10x1,5 / M6x1,0
1x spare screw for adapter
1x Case

Technical data:
Total length of the sliding hammer: 390mm
Clamping thread of the drawbar of the hammer: M10
Weight of the hammer( slip no. Part): 850 g

Usage:
The kit allows you to disassemble the bearings from the bearing after disassembling the shaft. The set is intended for bearings with a hole diameter of 8 â € “58mm
Adapters are intended for bearing disassembly, which are inserted into the bearing bore and, after expansion, are firmly held behind its inner ring. The kit contains 10 adapters.
A sliding / reversible hammer or a puller is used to develop the pulling force.

Instructions for use: - see attached photos and video
1. Select the appropriate collet according to the bearing size
2. Insert the collet into the hole “so that its edges are behind the bearing ring
3. Screw / unscrew the middle mandrel of the collet with two wrenches until the collet is fastened / disassembled in the bearing ring
4. Attach the collet to the slide of the slide hammer or to the puller
5. Move the hammer back sharply so that it strikes the bar adjusting ring. When using the puller, it is enough to gradually tighten - always tighten for a while and wait for