RUKO

Holder, mandrel for clamping bimetallic crowns with diameters of 32-210mm Drill diameter: 6.5mm Clamping shank: SDS For clamping drill bits diameter 32-210mm Thread: UNF 5/8 "x 18 feet per inch The holder includes an HSS drill. Type: A7

Needle set with telescopic holder, with two blades / legs Clamping diameter of legs: 1,6mm

Replacement needle bar, scraper, deburrer E 100(replacement for BS1010) | Clamping diameter 3mm | Total data Width 50mm Usage: Outer edges inner side of pipe Suitable for steel, aluminum, copper, plastic

Usage: External edges inner side of tube Suitable for brass and cast iron

Usage: External Edge Sheets Inside and Outside tubes - ojehluje both edges at one time Suitable for steel, aluminum and copper

Accelerator, tube and plate deburring machine. With non-replaceable blade. Set of bracket and two different Ojhlovací knives. The total length of the bracket (without the tip) is 120 mm. Holder is all-metal. One piece knife, type E, part of the package

Tube and Tube Dehumidifier Set of bracket and two different O-rings. The total length of the holder (without the tip) is 130mm. Holder is all-metal. One piece knife, type E, part of the package

Weldon clamp holder 3/4 "(19,05mm) for carbide drill HAND Clamping shank: weldon 3/4" Clamping thread: M18x6 P1.5(thread M18x1 .5 with six-helix)

Centering pin for carbide drill HAND Diameter: 6,35mm Length: 123mm

Carbide core drill / twist / carbide drill bit MBL, without shank, without center drill Diameter: 42 mm Max. drilling depth steel / stainless steel: 20.0mm Max. drilling depth in soft metals / non-ferrous metals: 28.0 mm Max. drilling depth in hand drill: 6mm in steel Tooth width: 4mm Clamping thread: M18x6 P1,5(thread M18x1, 5 with six-helix) Clamping shank: not included(see related products) Center drill: not included(see related products)) It has tensioned carbide teeth, which allow easier drilling with less compression force. The drill must not be overheated, otherwise the carbide blades will fly off. We recommend using drills with a diameter of more than 65 mm only in a column drill with clamping over Morse taper. Application: * Steel with strength up to 900MPa * Steel with strength up to 1100MPa * Steel with strength up to 1300MPa * Cast iron * Stainless steel and titanium alloys * Aluminum, brass, bronze, plastics

Holder with cylindrical shank for carbide drill RUKO Clamping shank: cylindrical with three flats Center drill: 6, 0 mm x 72mm, HSSCo5(Order No. 113216) Clamping thread: M18x6 P1.5(thread M18x1.5 with six-screw)

Morse shank holders for carbide drill RUKO Clamping shank: morse taper 2 Centering drill: 6.0 mm x 72mm, HSSCo5(obj. No. 113216) Clamping thread: M18x6 P1,5(thread M18x1,5 with six-helix)