Quick couplings and terminals

Double sided coupling nipple for air hose diameter 9 mm Overall length: 41mm Diameter through cylindrical nipple part: 10mm Diameter through nipples on nipple: 10mm

Double-sided coupling nipple for air hose diameter 13 mm Overall length: 49mm Diameter through cylindrical nipple part: 12,6mm Diameter through nippers on nipple: 12,6mm

The nipple nipple has a diameter of 15.5mm The height of the end piece with the lever is 31mm

1/4 "

1x 6mm Hose Nipple with Seal

1x Hood 9mm with seal

9mm Hose Coupling Hose 1x Hose Nipple 9mm with Gasket 1x Hose Connector Connector for 1/4 "Female Thread 1x Hose Connector with 1/4"

Air Duct Adapter 3/8 "G Female Thread 1/2" Male Thread

Valve can be set to 8 to 12 bar pressure The pressure / pressure relief valve serves as a fuse against exceeding the maximum pressure in the reservoir CAUTION - does not replace the pressure switch! Fittings: 1/4 "G with 8mm length Hexagon: 14mm (inside 10mm) Pressure release can also be manually wrapped around a ring that is connected to a sealing cone < The valve can be adjusted to a lower opening pressure - procedure: Removing the ring (key ring), removing the red plastic cap Using the 10 and 14mm wrenches, the lock nut is released. Pressure air pressure to the pressure at which the safety valve should be opened 10mm sensibly allow the valve insert until the valve releases and the pressure leak Tighten the key # 14. Press the pressure in the reservoir and re-press Observe the data on the pressure gauge and check the value at which it opens this safety valve If necessary fine-tune the procedure as described above.

Cross 3/8 "G Thread depth 12, 5mm

Set of 3 adapters with thread M8x0,75 - Conical nozzle for inflatable water lounges, M8x0,75 End caps have an external clamping thread. a fuse that is commonly used with tire fillers Alternatively, in the corner end with a lever, which is also on offer.

1/2 "threaded quick connect coupling G 1/2" female thread This SE4 and SE8 Series couplings are compatible with steel, steel, silver surface Diameter of the mandrel is 11.9mm, thread depth 13mm Overall length 36mm Outer shear hexagon has a dimension of 25mm Lumber of the mandrel is 6.8mm