Machine needle 10-46mm 60° D16 / D10 outer edges, KOPAL

Machine chisel for outer edges / machine needle

Range: 10-45mm
Bevel angle: 60°
Number of slots for edge inserts : 2
Clamping shank: cylindrical dia. 16mm and dia. 10mm

The coaster is delivered without a run , these can be purchased with a sharp angle:
a) 0 Â °(cat. No. 02-317), suitable for brass, bronze, cast iron, heat-resistant steel
b) 14 Â °(cat. No. 02-315), suitable for special Bronze, plexiglass
c) 20 Â °(cat. No. 02-318), suitable for ordinary steel, copper, plastics, stainless steel and d) 20 Â ° TiN(cat. No. No. 2T315B), suitable for ordinary steel, stainless steel, inconel, titanium
e) 25 Â °(cat. No. 02-319), suitable for aluminum, iron, sheets

Dimensions of the needle:
Overall length: XXmm
Diameter of the front part: XXmm
Diameter aluminum nut dimensions: XXmm and XXmm
Clamping shank length: XXmm

Blade insertion procedure and edge / chamfer height adjustment
1) Loosen the worms on the body of the needler(in the milled groove).
2) Insert the body into the body, secure it with two worms.
3) Adjust the chamfer height by tightening / loosening the aluminum nut.
4) Make sure that the runner is not drowned in the body of the needle, if so, rearrange the aluminum nut and check so that the runner protrudes.
5) Always tighten the aluminum nuts with the sprocket.