Liquid change

Extractor and liquid filler Simple operation, similar to a sprayer, for fast and clean replenishment or removal of liquids. Suitable example for removal Leveling or applying brake fluid, antifreeze, power steering fluid, transmission oil and coolant. Can also be used to exchange fluids for replenishment or repair. Lightweight and easy to clean. Comes with a flexible hose and a leak-proof closure. Maximum liquid temperature: 60 Â ° C / 140 F. ° F. Content 500ml Hose length: 280mm Extractor body length: 400mm Body diameter: 70mm

The suction cup is suitable for pumping liquids - eg motor oils. No longer need to dismantle the bottom cover plates, raise the car, take the home for the turkey and then wipe the polished floor as well ..... Dust extraction is carried out on the heated engine. The tube is inserted through the hole on the oil dipstick. Set contains: container 1,6l, hose inner diameter 5mm, length 1m, tube inner diameter 8mm, length 1,3m.

Piston pump - for suction and filling of oil Drawbar pump, pumping Content: 500ml / 500cm3 * Packaging is without hoses Do not use on: petrol, thinner and brake fluid

Grease sprayer metal, galvanized, suitable for suction and filling oil, without hose / attachment, it must be purchased separately Content: 500ml / 500cm3 Thread: G 1/8 "(M10x1) Dimensions: diameter 57mm x length 335mm Standard: ÄOSN 231430 Used to extract old used oils from various machines and equipment. , Thinner and brake fluid

Hose length: 300mm Thread: G 1/8 "(M10x1) Hose tip: inner diameter 4 , 5mm outer diameter 6mm / 9mm Suitable for use with lubrication press M03695 Do not use on: Petrol, thinner and brake fluid

Hose length: 500mm Thread: G 1/8 "(M10x1) Hose tip: inner diameter 4 , 5mm outer diameter 6mm / 9mm Suitable for use with lubrication press M03695 Do not use on: Petrol, thinner and brake fluid

Plastic funnel, two-piece funnel, plastic funnel with steel sieve and adjustable nozzle. Diameter: 180mm (funnel is oval, max. funnel width: 235mm) Length of flexible hose: 160mm Length of hose: 270mm Total length : 370mm

Pumping pump, hand - pump with pump for pumping liquids Total length 180cm. Use is simple - immerse one end of the hose in the pumped liquid, seal the other part of the hose with your finger, and pump the rubber balloon several times. Release your finger and allow liquid to flow into the target vessel by gravity. For liquid to flow by gravity, the target vessel must be located lower than the source vessel. Hose is resistant to oil and fuel, universal use

Low Profile Plastic Bottle / Liquid Sink - Oil, Coolant, etc. Volume: 6.5 Liter Diameter: 38cm Height: 9cm Super tool to workshop or service