Flow and safety valves

Valve can be set to 8 to 12 bar pressure The pressure / pressure relief valve serves as a fuse against exceeding the maximum pressure in the reservoir CAUTION - does not replace the pressure switch! Fittings: 1/4 "G with 8mm length Hexagon: 14mm (inside 10mm) Pressure release can also be manually wrapped around a ring that is connected to a sealing cone < The valve can be adjusted to a lower opening pressure - procedure: Removing the ring (key ring), removing the red plastic cap Using the 10 and 14mm wrenches, the lock nut is released. Pressure air pressure to the pressure at which the safety valve should be opened 10mm sensibly allow the valve insert until the valve releases and the pressure leak Tighten the key # 14. Press the pressure in the reservoir and re-press Observe the data on the pressure gauge and check the value at which it opens this safety valve If necessary fine-tune the procedure as described above.

Flow valve with 1/4 "NPT thread < cross sections) Thread depth 12mm Overall length 40mm Hexagon socket: 17mm Steering wheel diameter 16mm < Conical sealing NPT threads can be cut on request on a conventional tubular cylindrical thread G (BSP)