Česká zakázková výroba
-
Preparation for advance measurement - Czech production
Thread 14x1,25mm - common candle. - Advance Adjustment: 1. Unscrew the spark plug and screw in the timer. 2. Slowly rotate the crankshaft until the piston is in the upper dead center - at this point, the stick of the meter is fully extended. 3. Secure the rod in this position with the side screw - turn the crankshaft about 1/3 turn back (counterclockwise). 4. Set the lead on the advance meter. This is done by screwing the top of the meter. 1 revolution is 1mm, the finer values ??are indicated on the body of the meter. Gently rotate the crankcase in the direction of the engine until the piston reaches the meter bar. 5.Set the breaker (the circuit breaker board) to the position where the contacts are disconnected. 6. The start of the disconnection is determined by the connected bulb, ohmmeter or thin paper. The gauge is suitable for adjusting the range of motorcycles
In stock17,18 € with VAT -
Preparation for measuring advance with an anemometer
Thread 14x1,25mm - common candle. Body length without thread: 60mm Included are two bars with a diameter of 5mm and lengths: 50 and 60mm. After assembly of the sticks into the adapter there is a stick overlap of 32mm and 42mm (including thread length) This adapter is fitted with an 8mm stem (8H7 hole)
In stock8,89 € with VAT