Calibers

W7 / 16 "x 14" Thread Calibration Wrench W 7/16 Thread Calibration Ring - Scrapper Number of strokes per inch: 14 Tolerance: Sh8 Caliber It comes from business dispensers. Caliber can be used and used.

W9 / 16 "x 12 W 9/16 Thread Calibration Ring - good Number of strokes per inch: 12 Tolerance: Sh8 Caliber It comes from business dispensers. Caliber can be used and used.

W9 / 16 "x 12" Thread Calibration Wrench W 9/16 Thread Calibration Ring - Scrapper Number of strokes per inch: 12 Tolerance: Sh8 Caliber It comes from business dispensers. Caliber can be used and used.

The caliber comes from above-standard stock, from the dispensary, it is either unused or slightly used Double-sided threaded calibration mandrel / limit threaded mandrel - ISO for metric thread Size: M18x1.5 - fine pitch Good scrap Tolerance: 6H (corresponds to 0.0 to 0.190mm) Standard: ČSN 254020 / CSN 25 4020 The caliber is from older stock, we cannot guarantee that it will pass calibration. We do not provide calibration for these older calibers.

Measurement advance parameters: Thread 14x1,25mm - common candle. Total height of meter: Indicator - It also goes where there is little room. Joysticks contain 13 sheets in the range of 0.05-1.0mm, length 100mm Adjustment of advance: 1. Unscrew the spark plug and screw in the timer. 2. Slowly rotate the crankshaft until the piston is in the upper dead center - at this point, the stick of the meter is fully extended. 3. Secure the rod in this position with the side screw - turn the crankshaft about 1/3 turn back (counterclockwise). 4. Set the lead on the advance meter. This is done by screwing the top of the meter. 1 revolution is 1mm, the finer values ??are indicated on the body of the meter. Gently rotate the crankcase in the direction of the engine until the piston reaches the meter bar. 5.Set the breaker (the circuit breaker board) to the position where the contacts are disconnected. 6. The start of the disconnection is determined by the connected bulb, ohmmeter or thin paper. The gauge is suitable for adjusting the range of motorcycles

Double-sided roller calibration mandrel / limit mandrel Good scrap Size: 1H7 Tolerance: H7 Standard: DIN7162, DIN7164

Double-sided roller calibration mandrel / limit mandrel Good scrap Size: 4H8 Tolerance: H8 Material: Hardened steel Standard: DIN2245, DIN7162, DIN7164

Caliber - limit calibration ring with size 4mm DIN 2250

Calibr. - Limit Calibration Ring, Precision Dimension 24,9995mm DIN 2250

Calibr. - Calibration Limit Ring with Exact Size 29,9995mm DIN 2250

Calibr. - Calibration Limit Ring, Exact Size 39.9980mm DIN 2250

Calibr. - Calibration Limit Ring with Exact Size 75.0000mm DIN 2250