Calibers
-
Lead measuring device with accessories
Measurement advance parameters: Thread 14x1,25mm - common candle. Total height of meter: Indicator - It also goes where there is little room. Joysticks contain 13 sheets in the range of 0.05-1.0mm, length 100mm Adjustment of advance: 1. Unscrew the spark plug and screw in the timer. 2. Slowly rotate the crankshaft until the piston is in the upper dead center - at this point, the stick of the meter is fully extended. 3. Secure the rod in this position with the side screw - turn the crankshaft about 1/3 turn back (counterclockwise). 4. Set the lead on the advance meter. This is done by screwing the top of the meter. 1 revolution is 1mm, the finer values ??are indicated on the body of the meter. Gently rotate the crankcase in the direction of the engine until the piston reaches the meter bar. 5.Set the breaker (the circuit breaker board) to the position where the contacts are disconnected. 6. The start of the disconnection is determined by the connected bulb, ohmmeter or thin paper. The gauge is suitable for adjusting the range of motorcycles
In stock29,11 € with VAT